Pick up some cobalt drill bits and cutting fluid, they worked really well. I broke one at the beginning of the second slider so get 2 or 3 to be...
I have over 30K on my 2016 Latitude 4x4 with the 1.4L and I have had no issues so far. I have added the GFB diverter valve and some larger A/T...
Do you get any road noise / whistling with that rack? Your setup looks great! I love the Valkyrie ladder!
I would love this! That or just make 1st a granny gear and run 2nd-6th like a 5 speed, kind of like how the Trailhawk's "4WD Low" is now.
Seconded if the offered it in a manual transmission!
I had a similar issue after I updated the UConnect software. The fix was simply to reset the bluetooth connection (delete your phone from the...
Are these still available?
Just one, I would prefer to have a full sized spare rather than the donut they call "full sized".
How much?
To reset the oil change light: 1. Turn the car to run (do not start the engine) 2. Fully depress the gas pedal 3 times slowly (within 10 seconds)...
Just got a notification from ATP for their new front skid plate, which they say fits all renegades. It looks like they just have pre-orders at...
Did you ever get some pics of the fender liner plate? I could not get the slider to go on with the plate there and I would love to see how you got...
Awesome, thanks!
I was wondering if it was for crash safety, guess I should find a way to get it back on there.
So I just got the Daystar sliders for my 2016 Latitude 1.4L 4x4 and the passenger side went on just fine. However after removing the factory trim...
I did install the lift myself, but I did not take any photos during the process. There are plenty of lift kit install write-ups floating around so...
No problems with the kit so far and I have approx. 4000 miles on it now. The only issue I had was when I installed the kit I pinched the...
I pinched the cv boot when I was installing the lift. For some reason the passenger front strut tends to be a lot tougher of an install. Sent...
So the install went pretty smooth. It took me three hours start to finish, and considering this is the first time I've pulled an axle, I consider...
I here ya there! The part arrived yesterday and it looks like it is correct, I'm going to pick up a few supplies (mostly beer) and tackle it tomorrow.
Separate names with a comma.