Installing front offroad lights, wiring issue.

Discussion in 'Renegade Modified Tech' started by rostnes, Aug 10, 2017.

  1. rostnes

    rostnes New Member

    Joined:
    Jun 5, 2017
    Messages:
    11
    Location:
    sweden
    Hi all
    I just bought 3 pc 9" offroad lights 120w each. I'm mounting them on a front bar.
    I have'nt figured out yet the best way of getting the wiring harness into the engine compartment without drilling or ripping the car front apart.
    All you who installed offroad lights or led bars, which way did you take.
    I'll appreciate all the help I can get, pics etc.

    Thanks in advance

    Sent from my SM-G925F using ToasterJeep mobile app
     
  2. Conydetition

    Conydetition New Member

    Joined:
    Aug 10, 2017
    Messages:
    1
    Location:
    Sweden
    The easiest way for me when i mounted my ledbar was to lower the cable straight down from the left side (car direction) headlight and open the little cover next to the foglight. And then push the cable to the radiator area.
    There are an rubber flap the you can wiggle it through.

    No tools was required on my limited diesel.
    I have eu spec halogen headligts so might be different for you.
     
    rostnes likes this.
  3. jorgeq1972

    jorgeq1972 New Member

    Joined:
    Dec 13, 2016
    Messages:
    10
    Location:
    Bogotá, Colombia
  4. Sheep

    Sheep New Member

    Joined:
    Apr 19, 2017
    Messages:
    6
    Location:
    IL
    There is a fairly large rubber plug under the drives side dash located To the left of the break pedal. Cut a hole in that and fish threw the wire. Super easy.
     
    Last edited: Aug 20, 2017 at 6:53 AM

Share This Page