It's OK - we call it 'Art'. [ATTACH]
Nice looking Renegade... I rather like that decal.
ARB53B on 450R mounts - all pretty darned quiet here.[ATTACH] [ATTACH]
I also chose to follow these instructions while installing the Tekonsha T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector Item #...
I use this - has worked great for the past ten years on my HHR. I have the two-bike model, but it's also offered in a four-bike version....
Highland Sportwing - with Fulton Sportwing Accessory Shank with 1-1/4-Inch Receiver Mount and 4-Inch Rise - Available on Amazon and from other...
Yes, it cuts departure angle dramatically - not for everyone for sure.
It simply works... for me.
Yes - Bring back the white spokes. Nice lookin' CJ.
"Tonto Got a Headdress" or... I tied my Old Town Pack canoe down on the Thule load bars - Plan 'B' Having just worked out what I thought would...
Thanks Fred for the detailed write-up and the photos. Being new to the forum, I just found this today - a bit late, but appreciated nonetheless. I...
Going solo, I found that installing the drawbar balanced the hitch well enough to be able to wrestle it up onto the floor jack once in place under...
Poor fitment of collar around the receiver tube allows for areas of premature corrosion. The ugly gap on the bottom of the collar is just an...
Yes, you lose considerable departure angle with this hitch - No, it is not for everyone. Mounted on a FWD Latitude that does no off-roading. My...
On a flat garage floor surface, the top of the receiver tube hole measures 9-5/16" from the floor. The bottom of the tube collar measures 7-11/16"...
Cleaning it up before installation - getting all of the damaged stickers and decals off - along with cleaning off 18 months of crud and dirt.
Made in Mexico
Separate names with a comma.